  |
|
 Corporate
Overview |
||
| Mission | ||
| Marketing
and Sales |
||
| State
of the Art Technology and Quality |
||
| Marketing
and After-Sales Service |
||
| Contact
Information |
||
|
|
| Loop-IP6810 Self-Healing Ring Network Termination | |
 |
|
|
|
- Full
front access (ETSI) unit comply with IP30 standard - Desktop,
wall, or DIN Rail mounting -
Compact
intelligent FX packet optical ring with layer-2 switch capability - WAN
port with OA&M function -
Dual
SFP optical housing interfaces - Tributary ports - 3 ports 10/100 BaseT Ethernet (with PoE option available in DC 48 only) -
2
ports RS232/485 Interfaces, user selectable via 2-port DIP switch -
2 Dry-Contact
for input and 2 Dry-Contact for output; support point-to-point and point to
multi-point - Power modules - On-board fixed single AC
supply - On-board fixed single/dual
DC modules with dual feed - Auto-discovery topology,
auto-diagnostic and remote-configure for easy plug-and-install (up to 64 units) - Ethernet Function: -
Loop
Ethernet Automatic Protection Switching (LEAPS) -
Fault recovery time: less than 50 ms (normally
3~50 ms) - Point-to point: fault recovery time less than
8 ms - Up to 15 units: fault recovery time less than
25 ms -
IEEE 802.1w RSTP,
802.1s MSTP* - IEEE 802.3x Flow Control, - Up to 1024 MAC address - High speed, asynchronous RS232/RS485 for
point-to-point, point to multi-point, or Omni-bus-like applications - Master/Slave units setting by using DIP
switch - Auto-negotiating or forced speed
for speed and Full/Half Duplex for Ethernet ports - Full/Half Duplex for tributary Ethernet ports -
Alarm Relay and ACO (Alarm Cutoff)
button - Remote firmware download via TFTP &
Z modem - Remote configuration upload &
download via TFTP - Management port and interface - In-band management - RS232 console via DB9 connector - SNMP v1, v2, v3 - SSH v2 - Telnet -
LoopView
GUI - RoHS Compliance |
 |
|
The Loop-IP6810 is a self-healing ring network termination unit (NTU) with a built-in L2 switch. It can be desktop, wall or DIN Rail mounted. LEAPS, RSTP, or MSTP* Ethernet Ring protection or point-to-point protection is facilitated in 100 Base-FX. All end equipments can be either in packet format via Ethernet ports or serial data via RS232/485 interfaces which will be converted into packet format within IP6810. The IP6810 has two WAN optical interfaces, two RS232/485 DTE interfaces, three Ethernet LAN interfaces, two sets of dry contact IN/OUT interfaces, and one alarm relay connector. TheIP6810 has a hardening option which will support ¡V20„aC to 70„aC. The IP6810 supports auto-discovery to discover all units on the ring, and also supports remote-configure for the ease of installations. The IP6810 supports single AC, single DC or dual DC to field requirement. PoE option is also available. The IP6810 facilitates automation systems, SCADA systems, surveillance systems, traffic control systems, transportation systems and IP networking with robust protection in ring, point-to-point, or Omni-bus-like topology. Easy installation and configuration also make maintenance or further expansion more efficient and cost-effective. |
Design By CREATOP Interactive Media, Inc.